Innovative, custom-built logging solution to solve water production challenge in multi-lateral well

Cased Hole Services

Customer challenges

A new multi-lateral oil and gas well in East Texas was producing over 1,000 barrels of water a day
The client sought a solution to isolate the water source downhole, which in turn would optimise production and reduce expensive water disposal costs

Expro Excellence

Expro proposed a custom production logging tool string to ascertain which lateral section was the source of the water - the well was flowing at 40% water cut (mainly from one lateral), when only 5-10% was expected
Produced in-house, it was critical that the custom production logging tool string's sensors were capable of passing through small restrictions in the tubing, while simultaneously running a fluid density inertia (FDI) tool to help water/oil phase identification - the tool string was able to pass through a 2 3/8" x-nipple with an internal diameter of 1.865"
Combined with the FDI tool, the pressure and temperature sensors allowed Expro to characterise each phase type within the well, and their point of entry to the wellbore
The main wellbore plus one additional lateral were successfully logged; the well was entered twice, over two days
The liner top was 9,500 ft (vertical); the wells went horizontal after entering the lateral sections; running e-line in surface read out (SRO) Expro were able to enter the lateral sections to about 70 degrees deviation - this was sufficient to ascertain if there was water production in each lateral
Expro log interpretation specialists provided appropriate onsite analysis for where water shut off should happen

Value to client

Tailored solution: modifications and collaboration with the client to find the solution followed by some temporary patch and packer options to isolate the water producing zones
Enhanced data: wealth of data collated allowed the client to identify the water source and plan for future remediation; real-time SRO facilitated faster decision making
Efficiency: running the custom logging string (with multiple sensors) in tandem with the FDI on one string saved two full days crew time as well as avoiding the use of a rig as an e-line unit and picker were used instead
Final water cut reduced to between 5-10%

Customer challenges

A new multi-lateral oil and gas well in East Texas was producing over 1,000 barrels of water a day
The client sought a solution to isolate the water source downhole, which in turn would optimise production and reduce expensive water disposal costs

Expro Excellence

Expro proposed a custom production logging tool string to ascertain which lateral section was the source of the water - the well was flowing at 40% water cut (mainly from one lateral), when only 5-10% was expected
Produced in-house, it was critical that the custom production logging tool string's sensors were capable of passing through small restrictions in the tubing, while simultaneously running a fluid density inertia (FDI) tool to help water/oil phase identification - the tool string was able to pass through a 2 3/8" x-nipple with an internal diameter of 1.865"
Combined with the FDI tool, the pressure and temperature sensors allowed Expro to characterise each phase type within the well, and their point of entry to the wellbore
The main wellbore plus one additional lateral were successfully logged; the well was entered twice, over two days
The liner top was 9,500 ft (vertical); the wells went horizontal after entering the lateral sections; running e-line in surface read out (SRO) Expro were able to enter the lateral sections to about 70 degrees deviation - this was sufficient to ascertain if there was water production in each lateral
Expro log interpretation specialists provided appropriate onsite analysis for where water shut off should happen

Value to client

Tailored solution: modifications and collaboration with the client to find the solution followed by some temporary patch and packer options to isolate the water producing zones
Enhanced data: wealth of data collated allowed the client to identify the water source and plan for future remediation; real-time SRO facilitated faster decision making
Efficiency: running the custom logging string (with multiple sensors) in tandem with the FDI on one string saved two full days crew time as well as avoiding the use of a rig as an e-line unit and picker were used instead
Final water cut reduced to between 5-10%

Contact

For further information, please contact: